Page 1 of 1
Occupancy Sensor
Posted: Thu Nov 17, 2016 2:37 pm
by cottoa00
Want to add an outdoor motion sensor ... Can I get off the shelf version and just add the resistor like the occupancy sensor we got from LumenCache ?
Re: Occupancy Sensor
Posted: Thu Nov 17, 2016 4:27 pm
by dc
L-WP1 switchpucks respond to transitions Off to On (occupied begins) and On to Off (occupied ends). The A/D switchput input expects to see a 7500ohm resistor in series with the data lines. Connect to the C (Common) and S (Switch/data) terminals of the SIB-SE or Green (Common) and White (Switch/data) wires in the SIB-K. If your occupancy sensor has an open drain output, connect the 12V accessory +/- and only the White or S terminal to the sensor output.