Occupancy Sensor

Need help getting started with LumenCache products? Ask a friend.
cottoa00
Posts: 6
Joined: Mon Nov 14, 2016 3:26 pm

Occupancy Sensor

Postby cottoa00 » Thu Nov 17, 2016 2:37 pm

Want to add an outdoor motion sensor ... Can I get off the shelf version and just add the resistor like the occupancy sensor we got from LumenCache ?

dc
Posts: 124
Joined: Thu Dec 20, 2012 4:23 am
Contact:

Re: Occupancy Sensor

Postby dc » Thu Nov 17, 2016 4:27 pm

L-WP1 switchpucks respond to transitions Off to On (occupied begins) and On to Off (occupied ends). The A/D switchput input expects to see a 7500ohm resistor in series with the data lines. Connect to the C (Common) and S (Switch/data) terminals of the SIB-SE or Green (Common) and White (Switch/data) wires in the SIB-K. If your occupancy sensor has an open drain output, connect the 12V accessory +/- and only the White or S terminal to the sensor output.


Return to “General Questions”

Who is online

Users browsing this forum: No registered users and 1 guest